Heat-glo-fireplace HEAT & GLOW XLR-N-AU Manuale Utente Scaricare il pdf (Pagina 46)

Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. o • 1/1346

13

Finishing 

A. FramingandFinishingInstructions

WARNING! Risk of Fire! Comply with all minimum clear-

ances to combustibles as specied. Framing closer than the

minimums listed must be constructed entirely of noncom-

bustible materials (i.e., steel studs, concrete board, etc.)

FinishingInstructions

It is important to follow the framing and nishing instruc-

tions to ensure proper placement of replace into the sur-

rounding framing/nishing materials.

Wall sheathing materials 3/8 in. (10 mm) thick are

specied in this installation manual to properly align with

the factory-installed non combustible material.

WARNING! Risk of Fire! DO NOT remove the factory-

installed non-combustible board or cover it with combus-

tible material, such as:

• Drywall (gypsum board)

• Plywood

• Materials that do not meet the ASTM E 136 Non-com-

bustibility standard (below).

Removal of factory-installed, non-combustible board and/

or use of materials not meeting the ASTM E 136 standard

may cause re.

Non-CombustibleMaterialsSpecication

Material which will not ignite and burn. Such materials are

those consisting entirely of steel, iron, brick, tile, concrete,

slate, glass or plasters, or any combination thereof.

Materials that are reported as passing ASTM E 136,

StandardTestMethodforBehaviorofMaterialsina

Vertical Tube Furnace at 750 ºC and UL763 shall be

considered non-combustible materials.

SettingtheFireplaceintotheFraming

Unlike many traditional, single-sided Heat & Glo replaces,

this replace is recessed into surround framing. The left

and right nailing tabs were designed so the replace

is recessed to the correct location within the framing

materials.

1. Bend two nailing tabs away from replace 180° on both

left and right nailing tabs. Do not adjust the column

standoffs. See Figure 13.1.

2. Screw each nailing tab to the adjoining framing material.

Ensure that the air space clearance is maintained on

the sides of the replace. See Figure 13.2.

Figure13.1NailingTabsInstallationPosition

Figure13.2FrontSideFinishingDetail

FRAMING

1-1/4 in. (30 mm)

3/8 in. (10 mm) BUILDING MATERIAL

1-1/2 in. (37 mm)

FACTORY-INSTALLED

NON-COMBUSTIBLE BOARD

NAILING TABS

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 69 70

Commenti su questo manuale

Nessun commento

Heat-glo-fireplace HEAT & GLOW XLR-N-AU Manuale Utente Pagina 46

Commenti su questo manuale

Prodotti e manuali riguardandi Forno Heat-glo-fireplace HEAT & GLOW XLR-N-AU