Heat-glo-fireplace HEAT & GLOW XLR-N-AU Manuale Utente Scaricare il pdf (Pagina 51)

51Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. o • 1/13

Non-Combustible Finish Material 0 - 4 in. (0 - 102 mm) Thick

Bottom Joint

3/4 in (19 mm)

3 in. (76 mm)

3/4 in (19 mm)

Figure13.14NoncombustibleSurfaceFinishingMaterial

 0-4in.(0-102mm)Thick-InsideFitMethod

 (TonicDecorativeFrontOnly)

FACTORY-INSTALLED

NON-COMBUSTIBLE

BOARD

\\\

DRYWALL OR

EQUIVALENT

3/8 in. (10 mm)

20-1/2 in. (520 mm)

APPLIANCE

OPENING (HEIGHT)

3/4 in.

(19 mm)

3 in. (76 mm)

0-4 in.

(0-102 mm)

0-4 in.

(0-102 mm)

Figure13.13InsideFitMethod(TonicDecorativeFrontOnly)

Non-CombustibleFinishMaterials

0in.to4in.(0mmto102mm)ThickInsideFitMethod

The Tonic decorative front is approved for inside t ap-

plications. Non-combustible nishing materials up to 4

in. (102 mm) thick can be installed around the front (left,

right, top, and bottom).

For the Tonic decorative front inside t applications, the

decorative front must be installed tight to the nishing

anges and must not overlap any nish material.

Ensure that no non-combustible nish materials are in-

stalled within 3/4 in. (19 mm) of the replace opening.

The 3/4 in. (19 mm) spacing is required to provide clear-

ance for removing and installing the Tonic decorative

front. See Figure 13.14.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 69 70

Nessun commento

Heat-glo-fireplace HEAT & GLOW XLR-N-AU Manuale Utente Pagina 51